Draining And Refilling - Sundance Spas Altamar Owner's Manual

A
B
C
B
Loosen filter nut (A) to provide clearance,
then remove used MicroClean Plus filter
cartridge (steps B-C). Remove suction
fitting filter (D) and clean with mild liquid
soap solution and warm water, then reinstall
over suction fitting.
D
Trapped
Bubbles
Submerge new filter cartridge in spa and tilt
each end upward to remove most of the
air bubbles trapped inside the filter.
your Sundance dealer. An optional pleated filter cartridge is also avail-
able from your Sundance dealer (#6540-488). This filter can be cleaned
and reused for up to two years but does not maintain the same water
quality and clarity as the standard MicroClean Plus cartridge.

13.2 Draining And Refilling

About every 3 to 6 months, you will should replace the hot tub's water.
The frequency depends on a number of variables including the amount of
use, attention paid to water quality maintenance, etc. You will know it is
time for a change when you cannot control sudsing and/or you can no
longer get the normal feel or sparkle to the water even though the key
water balance measurements are all within the proper parameters.
TURN POWER TO HOT TUB OFF!
Filter
Nut
A
D
Air
C
Replace (throw-away) the MicroClean filter cartridge
every 6 months, or as needed! DO NOT reuse this
cartridge for any reason!
E
B
1. Install new filter cartridge, then tighten filter nut until
it just touches filter face. DO NOT OVERTIGHTEN!
2. Turn power to hot tub back on.
Replace MicroClean
cartridge every 6
months, DO NOT
Reuse for any reason!
Filter
Nut
A
C
Page 55
Plus
A