Activate Jets Pumps - Sundance Spas Altamar Owner's Manual

4. Activate Jets Pumps

Turn on all jet(s) pumps and blower to ensure proper mixing
when adding start up chemical in step 5.
5. Add Start-Up Chemicals
Add the hot tub water chemicals as recommended by your Sundance
Dealer. See section titled "WATER QUALITY MAINTENANCE",
(page 59) for general guidance.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 3.0-4.0 ppm Chlorine or
2.0-4.0 ppm Bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool And Spa Professionals printed on the
inside cover of this manual. If sanitizer levels cannot be stabilized,
perform the decontamination procedure steps 9-15 on the following
page. Note: the "decontamination procedure" steps 9-15 should
also be used after the hot tub has been "Winterized" (sec. 13.7) or
has been sitting without power for an extended period.
7. Set Hot Tub To Heat
To warm hot tub water to a comfortable temperature, follow
these steps:
• The LCD display on the control panel displays the actual tem-
perature of the hot tub water. Press either the COOLER (Down)
or WARMER (Up) button once to display the "set" temperature
for 5 seconds. If you want the water to heat to a different tempera-
ture, simply press COOLER or WARMER within 5 seconds. The set
temperature increases or decreases by one degree each time one of
these buttons is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Page 16