4-3
1
2
4
7
9
Removing the sprocket
– Use holding wrench 510.12.012.000 to hold the sprocket
you remove the screw
– Remove the sprocket, distance bushing and O-ring.
Removing the ignition cover
– Remove the 7 screws on the ignition cover and take off the ignition
cover
3
– Remove the ignition cover gasket.
– Do not lose the needle rollers
Removing the starter drive
– Remove the torque limiter
– Remove the starter idler gear
5
6
Removing the pulse generator
– Remove the screw
– Pull the cable support sleeve
the cable.
8
– Remove both screws
– Remove the pulse generator including the holder.
with the spring washer.
2
.
3
.
4
.
5
.
6
and take off the retaining bracket.
7
out of the engine case and unthread
8
.
9
while
1