Mounting Engine Sprocket; Mounting The Ignition (Kokusan) - KTM EXC Repair Manual

2
C
B
A

Mounting engine sprocket

– Lubricate O-ring
– Slide distance bushing
position.
1
– Slide sprocket onto the countershaft with the collar facing inward, and
fix it with the circlip
3

Mounting the ignition (Kokusan)

– Insert the woodruff key into the crankshaft.
– Apply Loctite 243 to 3 screws
the 3 screws all the way).
4
– Turn stator such that the mark
in the casing, and tighten the 3 screws of the stator.
– At engines with ignition type 2K-4 the marking
the marking on the stator.
– At engines with all other ignitions (not SEM) the marking
coincide with the marking on the stator.
– Mount the rotor.
– Mount the detent edged ring and the nut.
– Hold the rotor with the holding spanner and tighten the nut with 60
Nm (45 ft.lb.).
1
with oil and slide over counter shaft.
2
in position so that O-ring is in correct
3
(sharp edge facing outward).
4
and fix the stator (do not yet tighten
A
on the stator coincides with the mark
6-10C
C
must coincide with
B
must