Clutch Cover - KTM 450 SX-F Repair Manual

5-5
A
3
4
7
– Degrease the thread on the screws for the retaining bracket, apply
– Align the mark
1

Clutch cover

– Remove the screws on the bearing retainer and the retaining bracket
5
– Pry out the shaft seal rings
– Remove the lock ring
– Pry out the shaft seal rings
2
– Pry out the water pump shaft seal rings
6
Assemble in the reverse order, paying attention to the following items:
– Inspect the parts for damage or wear.
– Replace any damaged or worn parts.
– The shaft seal ring
– Press in new shaft seal rings (
– Press in the shaft seal ring
– Degrease the thread on the screws for the bearing retainer and apply
– Clean all ducts and make sure they are not clogged.
Loctite 243 and tighten to 6 Nm.
on the balancer gear with the mounting pin
A
.
2
.
4
has 3 spacer tabs.
7
inside one by one. Pay attention to the distance between the two
shaft seal rings.
shaft seal ring with the open side on the inside (towards the
3
retaining bracket ).
2
Loctite 243. Mount the retaining brackets
on the bearing retainer to 6 Nm.
.
3
.
5
and .
6 7
and ) with the open side on the
7 6
with the open side on the outside and
5
and tighten the screws
2
.
1