Clutch - KTM 450 SX-F Repair Manual

4
5
LOCTITE 243
1
2

Clutch

– Check the pressure piece
– Check the axial bearing
2
– Lay the pushrod on a level surface and check for runout.
3
– Check the length of the clutch springs
– Check the pressure cap sealing area
– Check the thickness of the lining disks (9 pieces)
flat.
– Check the clutch disks (8 pieces)
roughness or chipped material.
– Check the driver for damage and wear.
8
– Check the thrust face
9
0.5 mm, replace the lining disks and the outer clutch hub.
– Check the needle bearing
– Replace any damaged or worn parts.
6
3
for damage and smooth operation.
1
for damage and wear.
. Minimum length 39.0 mm (40.0 mm new), replace all 6 springs if necessary.
4
for damage and wear.
5
6
for mechanical damage and warpage. Replace the clutch disks if you detect any
7
of the outer clutch hubs and the lining disks for damage and wear. If the recesses are bigger than
for damage and smooth operation.
bk
7
. Minimum thickness 2.6 mm (2.7 mm new). The lining disks must be
8
9
bk
5-18