DataCard RP90 Plus E Hardware And Driver Installation Manual page 23

To set up IPSec Security using a printer certificate, do the following:
1.
Obtain the printer certificate and install it on the PC.
2.
Export the Printer Certificate and Certificate Authority (CA) Certificate to files.
A.
B.
C.
D.
E.
F.
G.
3.
Power on the printer. For best results, do not send any cards to print.
4.
Use the printer LCD panel to set IPSec Mode to ON. See the Printer LCD Panel
section of the User Guide.
5.
Use the printer LCD panel to set IPSec Type to Certificate.
6.
Install the printer using a USB connection and install the Status Monitor. See
using a USB connection" on page 9
page 30
7.
Open the Status Monitor as an administrator. See the Open the Status Monitor section
in the User Guide.
8.
Click the Printer Select tab. It shows the Security settings chosen on the printer in
steps 4 and 5 above. Do the following:
A.
B.
20
Open the Management Console by choosing Start > Run. Type mmc in
the Run dialog and click OK.
Start "Certificate (Local Computer)."
Open the personal store run the Certificate Export Wizard.
Choose "Personal Information Exchange PKCS#12 (.PFX)" as the
format.
Specify a password for the file. Allowed characters are upper and lower
case letters (A-Z), numerals (0-9), and the special characters hyphen (-),
underscore (_), open and close parentheses(), period (.), and the at
symbol (@).
Note the location of the file for use later in the procedure.
Export the CA Certificate also if it does not exist in file form.
for the steps to follow.
Click Details. The IPSec setting dialog box opens.
Choose the correct choice from the Download Type list.
and "Installing the Status Monitor" on
Installing the Printer Driver
"Install