Connecting The Power Cord(S) - DataCard RP90 Plus E Hardware And Driver Installation Manual

Connecting the Power Cord(s)

Warning: Always use a grounded power outlet that is not shared with other
electrical equipment.
1.
Check the plug. The power cords vary according to model and country of
purchase.
2.
Plug the power cable into the back of the printer.
Caution: Use an Automatic Voltage Regulator (AVR) if there is a possibility
of voltage fluctuations. Use an uninterruptible power source rather than an
AVR if there is a possibility of frequent power loss.
3.
If you use the optional RL90 laminator, plug the power cable into the back of
the laminator.
4.
Plug the power cord(s) into the facility power source.
Caution: Do not power on the printer until instructed to do so during the
installation of the printer driver.
RP90 Plus Card Printer Installation Manual 7