Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
How to Set Up a Gateway-to-Gateway VPN Configuration
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
"Advanced Virtual Private
A
FVS318v3 VPN Firewall
PCs
Figure 6-22
Follow the procedure below to set the LAN IPs on each FVG318 to different subnets and
configure each properly for the Internet.
The LAN IP address ranges of each VPN endpoint must be different. The connection will fail if
both are using the NETGEAR default address range of 192.168.0.x.
In this example, LAN A uses 192.168.0.1 and LAN B uses 192.168.3.1.
Procedure to Configure a Gateway-to-Gateway VPN Tunnel
Follow this procedure to configure a gateway-to-gateway VPN tunnel using the VPN Wizard.
6-22
Table 6-1 on page
Networking" to set up the VPN tunnel.
VPN Tunnel
v1.0, October 2005
6-4. If you have special requirements
Chapter 7,
B
FVS318v3 VPN Firewall
PCs
Basic Virtual Private Networking