How To Set Up A Gateway-To-Gateway Vpn Configuration - NETGEAR FVS318 - ProSafe VPN Firewall Router Reference Manual

Reference Manual for the ProSafe VPN Firewall FVS318v3

How to Set Up a Gateway-to-Gateway VPN Configuration

Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
covered by these VPNC-recommended parameters, refer to
Virtual Private
A
FVS318v3 VPN Firewall
PCs
Figure 5-22: Gateway-to-Gateway VPN Tunnel
Follow the procedure below to set the LAN IPs on each FVS318v3 to different subnets and
configure each properly for the Internet.
The LAN IP address ranges of each VPN endpoint must be different. The connection will fail if
both are using the NETGEAR default address range of 192.168.0.x.
In this example, LAN A uses 192.168.0.1 and LAN B uses 192.168.3.1.
5-20
Table 5-1 on page
Networking" to set up the VPN tunnel.
VPN Tunnel
January 2005
5-4. If you have special requirements not
Chapter 6, "Advanced
FVS318v3 VPN Firewall
PCs
Basic Virtual Private Networking
B