Table of Contents
Advertisement
Two cables are required to connect between the CD-ROM drive carrier interface board (B) and the
CD-ROM interface board (E). An IDE cable is used to connect between the 2x20 IDE connector on
both these interface boards as indicated in (1). A 1x2 power cable is used to connect between the
power connector on both of these interface boards as indicated in (2).
The CD-ROM drive carrier assembly inserts into the peripheral bay on the front of the system. The
mating connectors on the CD-ROM drive carrier assembly and the FPIO board are blind-mate style
connectors, and will seat fully when the horizontal handle on the CD-ROM drive carrier assembly is
fully secured.
Floppy Drive Carrier Assembly
The Floppy drive is installed in a Floppy drive carrier assembly before installing it into the system.
An exploded view of the Floppy drive carrier assembly is shown in Figure 19.
xSeries 343 Product Guide
1
1
A. CD-ROM drive carrier metal housing
B. CD-ROM drive carrier interface board
C. Two screws to connect interface board to metal housing
D. CD-ROM Drive
E. CD-ROM interface board
Figure 18. CD-ROM Drive Carrier Assembly
2
2
TP126
E
D
C
B
A
83
Advertisement
Table of Contents
