Fastener Torque Requirements - Milnor 30022H7x Service

F ASTENER TORQUE REQUIREMENTS È
The specifications in this section apply to 1/4 inch and larger Unified National fine and coarse fasteners used on
®
Milnor machines. This information is to be used only when torque specifications are not stated in the installation
or service instructions.
When tightening applicable fastener, abide by the follow-
ing precautions:
1. Always use new fasteners. Replace bolts, nuts, flat wash-
ers, and lock washers in the order shown on the parts
drawing.
2. Unless otherwise specified, use:
®
• Loctite
271 threadlocker or equivalent for bearing
housing mounting bolts from one half to one inch in di-
ameter.
®
• Loctite
277 threadlocker or equivalent for bearing
housing mounting bolts of one inch diameter or larger.
®
• Loctite
242 threadlocker for all other fasteners
requiring thread locking compound.
3. Use a torque wrench to assure proper tightness.
4. Never lubricate fasteners. The values specified herein are
maximum recommended torques and are calculated from
published ASTM and SAE data. Actual allowable torques
are application dependent and can vary for many reasons,
(joint types, gaskets, etc.). Use these values as a guide.
5. Although FIGURE 1 depicts hex head bolts, the table applies to all head types.
H ow Fasteners Loosen Ë
bly. With the fastener at the proper torque, 85% of the tightening torque is absorbed in the threads and under the
fastener head. The remaining 15% provides the friction that prevents the thread from slipping. When this friction is
overcome (by bending, thermal expansion, internal pressures, functional loads, or impact) the thread slips and loos-
ens. Although higher torques reduce the likelihood of thread slippage, if slippage occurs, the threads unwind and
the fastener loosens. Once thread slippage begins, vibration increases the rate of loosening.
Ë P reventing Loosening
cation of a threadlocking compound. Threadlocker provides lubrication during assembly, then hardens to seal the
threads against corrosion and provide resistance to thread slippage.
F asteners and Threadlocker Ê
—Standard threaded fasteners are manufactured with a clearance fit for easy assem-
—The most effective way to prevent loosening of threaded parts is by proper appli-
MSSM0101CE/9906AV (1 of 19)
F IGURE 1 Î
F astener Grade Markings Î
19
(MSSM0101CE)