Set Port Alert Filter Command - 3Com CoreBuilder 5000 User Manual

4-4 C
ONFIGURING THE
M
ODULE
Use the following command to set remote diagnostics:
SET PORT {slot. port } MODE {REMOTE_DIAGNOSTICS}
{slot.port}
In the command above, the last variable, slot.port, is optional. If
entered, both ports are placed into remote diagnostic mode and
referred to as buddy ports to each other. If you turn one port off (place
in non-remote diagnostic mode) then the other port is also turned off.

Set Port Alert Filter Command

This command allows you to override the Port Alert Filter feature on a
port-by-port basis. The Port Alert Filter feature enables or disables the
DMM delivery of port up and port down traps. You can use this
command to continue to monitor port status on crucial ports (file
servers, for example), while alerts from other ports are disabled.
Configure Alert Filter to:
Enable – To use the Port Alert filtering feature.
Disable – To allow all port up and port down alerts to display.
Use the following command to enable or disable the port up and port
down alerts for a port:
SET PORT{ slot.port } ALERT_FILTER {disable}
{ slot. all}
The following output is an example of the SET PORT ALERT_FILTER
command issued for port 1 of a 12-port module in slot 1:
CB5000> set port 1.1 alert_filter disable
Port 01.01 Alert Filter set to DISABLE
Perform the SET ALERT PORT_UP_DOWN FILTER command on the DMM
before you use the SET PORT ALERT_FILTER command on the module.
For more information on this command, refer to the CoreBuilder 5000
Distributed Management Module Commands Guide.
{NON_REMOTE_DIAGNOSTICS}
{enable}