6.1.3
REM24 Error Codes and Diagnostic Codes
The drive electronics are capable of rectifying some errors automatically. In this case the status
display will cease to flash. Please switch the remote on and off several times. Wait approx. 5
seconds each time before switching the remote on again. If this does not rectify the error, locate
the error using the flash codes shown below.
Flash code:
1 x flash
2 x flashes
3 x flashes
4 x flashes
5 x flashes
6 x flashes
7 x flashes
8 x flashes
Meaning:
Solution:
•
Module defective
Accessory error
•
(e.g. actuator
short-circuit)
•
Lifter raised or
lowered too far
(seat not at driving
height)
•
Connection on the
left motor
loose/defective
Left motor
•
defective.
Connection on the
•
right motor
loose/defective
Right motor
•
defective.
•
Fault/brake fault
on left-hand motor.
Connection
loose/defective or
motor defective.
•
Left motor
disengaged (GB-
motors)
Both motors
•
disengaged
(standard motors)
Fault/brake fault
•
on right-hand
motor. Connection
loose/defective or
motor defective.
Right motor
•
disengaged (GB-
motors)
Battery dead
•
Battery voltage too
•
high
•
Replace defective module See "Replacing electronic
Check accessory
connections, check
accessories
If lifter is raised, lower in
stages until the status
display stops flashing. If
lowered too far, raise lifter
in stages until the status
display stops flashing. If
at all possible, only drive
when the seat is at driving
height.
Check plug-in
connections.
Check/replace motor
Check plug-in
connections.
Check/replace motor
Check plug-in
connections.
Engage motor. Shut
electronics down and then
switch on again.
Engage motors. Shut
electronics down and then
switch on again.
Check plug-in
connections.
Engage motor. Shut
electronics down and then
switch on again.
Pre-charge battery
Switch lights on to lower
battery voltage
Check battery charger
Notes
components" on page 31
See "Checking an
actuator motor" on page
45
See User Manual
See "Checking the
cables" on page 41
See "Replacing and
calibrating drive motor"
on page 21
See "Checking the
cables" on page 41
See "Replacing and
calibrating drive motor"
on page 21
See "Checking the
cables" on page 41
See User Manual
See User Manual
See "Checking the
cables" on page 41
See User Manual
See User Manual
See User Manual of battery
charger
19