Invacare Typhoon II Service Manual page 27

•
Push the tyres with puncture-proof cores
onto the motor (on the rotor housing).
•
Position the wheel rim halves in the tyres.
The holes for the bolts in the wheel rim
halves and those in the rotor housing must
be aligned. While doing so, it can be helpful
to use the notches in the wheel rim halves
and in the rotor housing for the nonexistent
valves as a positioning aid and to align them.
•
Screw in three M8 x 30mm bolts by hand in
positions 1, 3 and 5.
•
Tighten bolts 1, 3 and 5 successively in a
clockwise direction by one rotation each
until a torque of around eight Nm is reached
(check with torque wrench if necessary).
This is necessary to ensure that the
wheel rim is evenly tightened onto the
rotor housing.
CAUTION!
Material damage hazard.
•
In the next steps DO NOT USE thread-locking fluid!
•
Screw two of the original M8 x 25 mm bolts
with Nord-Lock washers at positions 2 and 4
in and tighten to fingertight (max. 8 Nm).
27