Invacare Typhoon II Service Manual page 26

CAUTION!
There is a danger that the anti-tip mechanism will not function correctly after replacing the
motor or the gas pressure spring due to a change in distance between the triggering pin
on the gas pressure spring and the counter bolt.
• Check the that the anti-tip mechanism is functioning correctly after replacing a motor, and
readjust it if necessary.
•
The drive unit is refitted in reverse order.
•
Tighten the wheel bolts to 25 Nm.
7.1.1.4 Reassembling wheel rim and tyres on vehicle with pneumatic tyres
CAUTION!
Material damage hazard.
•
In the next step DO NOT USE thread-locking fluid!
•
Replace the inner tube in the tyre.
•
Insert the wheel rim halves once again.
•
Insert the countersunk screws with Nord-Lock washers and tighten slightly.
DO NOT USE screw locking!
•
Pump a little air into the inner tube.
•
Screw the wheel rims tightly together.
•
Ensure that the tyre outer is seated correctly.
•
Pump the tyres up to 3 bar air pressure.
•
Check that the tyre is seated correctly once again.
•
Screw the valve cap back on.
7.1.1.5 Reassembling wheel rim and tyres on vehicle with puncture-proof tyres
•
In order to refit tyres with puncture-proof
inner tubes, the inside and outside edges of
the tyre (1 and 3) and the inside surface of
the core (2) must be coated with tyre fitting
paste (soft soap).
26