v Take additional care when handling devices during cold weather as heating
Removing the cover
Complete the following steps to remove the server cover:
1. Review the information in "Before you begin" on page 36.
2. Turn off the server and all attached devices and disconnect all external cables
3. Remove the two screws from the rear of the server.
4. Pull out on the cover-release lever at the back of the server to release the cover.
5. Slide the cover back, then up and off the server.
38
Hardware Maintenance Manual: xSeries 300
static-protective package. (If your device is an adapter, place it component side
up.) Do not place the device on your system unit cover or on a metal table.
reduces indoor humidity and increases static electricity.
and power cords.
Cover release
lever
Attention:
For proper cooling and airflow, replace the cover before turning
on the server. Operating the server for extended periods of time (over 30
minutes) with the cover removed might damage server components.
Screws