Text Messages - IBM xSeries 300 Hardware Maintenance Manual

Sometimes the first error to occur causes additional errors. In this case, the server
displays more than one error message. Always follow the suggested action
instructions for the first error message that appears.
The following sections contain the error codes that might appear in the detailed
test log and summary log when running the diagnostic programs.
The error code format is as follows:
fff-ttt-iii-date-cc-text message
where:
fff
ttt
iii
date
cc
text message

Text messages

The diagnostic text message format is as follows:
Function Name: Result (test specific string)
where:
Function Name
is the name of the function being tested when the error occurred. This
corresponds to the function code (fff) given in the previous list.
Result can be one of the following:
Passed
Failed This result occurs when the diagnostic test discovers an error.
User Aborted
Not Applicable
Aborted
Warning
is the three-digit function code that indicates the function being
tested when the error occurred. For example, function code 089 is
for the microprocessor.
is the three-digit failure code that indicates the exact test failure
that was encountered.
is the three-digit device ID.
is the date that the diagnostic test was run and the error recorded.
is the check digit that is used to verify the validity of the
information.
is the diagnostic message that indicates the reason for the problem.
This result occurs when the diagnostic test completes without any
errors.
This result occurs when you stop the diagnostic test before it is
complete.
This result occurs when you specify a diagnostic test for a device
that is not present.
This result occurs when the test could not proceed because of the
server configuration.
This result occurs when a possible problem is reported during the
diagnostic test, such as when a device that is to be tested is not
installed.
13
Chapter 3. Diagnostics