IBM xSeries 300 Hardware Maintenance Manual page 60

6. If you have other options to install or remove, do so now; otherwise, replace
7. Reconnect the external cables and power cords; then, turn on the peripheral
52
Hardware Maintenance Manual: xSeries 300
v
Microprocessor
connector
Microprocessor
Heat sink
Heat sink
retainer
Microprocessor
orientation indicator
a. Peel the plastic protective strip off the bottom of the heat sink. Make sure
the square of thermal material is still on the bottom of the heat sink; if
not, replace the it with a new heat sink.
b. Align and place the heat sink on top of the microprocessor.
c. Align and push the heat-sink retainer through the groove in the center of
the fan sink.
d. Insert a small, flat-bladed screwdriver into the tab on the heat-sink
retainer.
e. Press the screwdriver down to snap the heat-sink retainer into place.
f. Connect the heat-sink power cable to the microprocessor heat-sink
connector (CPUFA1) on the system board. See "System board internal
cable connectors" on page 40 for the location of the microprocessor
heat-sink connector.
the cover. See "Installing the cover" on page 53 for instructions on installing the
cover.
devices and the server.
Lever