Polycom VSX 3000 Administrator's Manual page 75

5. Select and configure these settings:
Setting
Crypto Resync
Use RTS Signal for
Resync Pulse
Time Between
Pulses (sec)
Pulse Width
(millisec)
6. Select and configure these settings:
Setting
Enable Broadcast
Mode
Enable People+Content
Video Format
Video Protocol
Audio Protocol
Frame Rate
Description
Allows a VSX system connected to cryptographic
equipment to signal when it loses video synchronization
during a call. The cryptographic equipment can then
resynchronize with the far site.
Allows the system to send the resynchronization pulse on
the RTS signal. Select this setting if your data
communications equipment uses the V.35 or RS-449
capability of the serial V.35/RS-449/RS-530 network
interface.
Note: When you check this box, the RTS no longer
functions as the Request To Send signal.
Specifies whether the system should set the time
between resync pulses automatically or use the number
of seconds you enter.
Specifies whether the system should set the pulse
duration automatically or use the number of milliseconds
you enter.
Description
Enables support for H.331 broadcast transmissions
from the VSX system.
Broadcast mode enables the system to send video
and audio to many other system, such as large
satellite networks.
Enables People+Content for broadcast mode.
Specifies the resolution at which video is transmitted.
Specifies the protocol used to transmit video. Choose
the lowest protocol supported by all systems in the
conference.
Specifies the protocol used to transmit audio.
Specifies the frame rate to use.
Configuring Network Use
3 - 21