Chris-Craft 32 Launch (RJ) Owner's Manual page 219

Figure G-37
Docking Lights Switch Panel
ZINC
600 - 8 GREEN NOTE: This wire harness applies
640 - 8 GREEN
to the RJ Model only. The RK
1/2" RING
ZINK
600 - 8 GREEN has this harness incorporated
640 - 8 GREEN
1/2" RING
into the main hull harness.
18"
18"
DRAIN PLUG
DRAIN PLUG 640 - 8 GREEN
640 - 8 GREEN
#10 RING
#10 RING
GENERATOR
SEA STRAINER
55"
55" GENERATOR
SEASTRAINER
635 - 8 GREEN 635 - 8 GREEN
#10 RING
#10 RING
Figure G-38
Replacing The Docking Lights
NON-SERVICEABLE UNIT.
REMOVE AND REPLACE THE UNIT. IT IS NOT SERVICEABLE.
Step 1: Fasten the light to the hull with #6 x 3/4" stainless steel pan head
screws provided by the vendor in the light assembly. Caulking is not
necessary.
Step 2: Place the rear tab of the cover into the notch at the back of the light.
Step 3: Slide the cover forward and rotate it onto the light.
Step 4: Hold the cover to the light and tighten the final three screws.
G-33
Appendix G
028-2492
GENERATOR
630 - 8 GREEN
3/8" RING
GENERATOR
630 - 8 GREEN
3-8" RING
24"
12"
12"
7"
7"
24"
24"
24"
24"
BONDING BUSS
ALL WIRES ARE GREEN
8 GA: 600, 601, 630, 632,
635, 670
8"
GROUND JUMP
601-8 GREEN
8"
GROUND JUMP
601 - 8 GREEN
1/4" RING 1/4" RING
GENERATOR
SEACOCK
GENERATOR
SEACOCK
632 - 8 GREEN
632 - 8 GREEN
#10 RING
#10 RING
AIR CONDITIONER
SEACOCK
A/C SEACOCK
670 - 8 GREEN
670 - 8 GREEN
#10 RING
#10 RING
Figure G-39
Starboard Light
Figure G-40
Port Light
G-33
BONDING BUSS
ALL WIRES ARE GREEN
8 GA: 600, 601, 630, 632,
635, 670
028-2492
65"
65"