Connecting And Disconnecting Shore Power - Chris-Craft 32 Launch (RJ) Owner's Manual

Connecting and Disconnecting Shore Power

Use caution when connecting and disconnecting from shore power.
Follow proper connecting and disconnecting procedures otherwise
breakers to trip. Reduce power load before resetting any breakers.
This procedure connects shore power to a marina dock system.
To connect shore power:
1. Turn off all breakers at the dock station.
2. Attach power cord to the boat receptacles and lock in place. For safety reasons do not
attach the power cord to the dock first.
3. Plug in the cord at the dock station. Turn on dock station breakers.
4. Turn ON shore power control breakers located in the Port Aft storage locker.
5. Check for a reverse polarity indication. If a reverse polarity light illuminates, turn off dock
power immediately.
Refer to the Reverse Polarity section for corrective action.
6. Turn on the boats main AC breakers.
7. Turn on any boat systems desired,
do not exceed 30 amps.
To disconnect from shore power:
1. Turn off all breakers at the dock station.
2. Turn off the boats AC main circuit
breakers.
3. Disconnect the power cord from the dock
station.
4. Disconnect the power cord from the boat.
5. Retrieve and store the power cords.
6. Secure the power receptacle on the boat
with the waterproof caps.
3-41
electrical shock may result.
Exceeding 30 amps on one power cord will cause the main
Never operate the shore power system at less than 105 volts.
Systems
Figure 3-75.
Shore Power Cord Receptacle
Shore
Power
Receptacle
Phone & TV
Dockside
Hookup
3-41