Chris-Craft 32 Launch (RJ) Owner's Manual page 137

Spring Commissioning - (Continued)
Bilge Pumps
_______ Check bilge pump operation in both automatic and manual mode.
Boat Systems
_______ Check anchor locker drain with a water hose
_______ All raw water hoses and fittings visually checked
_______ Battery switch - ON
_______ Install Propeller
_______ Check fuel level in fuel tanks
_______ All fuel lines and connections visually checked
_______ Engine controls and cables visually checked and attached properly
_______ Trim tabs functional
_______ Check bonding and zinc protection
_______ All Bilge pumps operated manually and automatically
_______ Engines mounted with proper hardware and secured
_______ Harnesses and hoses are properly secured
_______ Check instrument operation and connections
_______ Hydraulic steering has no leaking hoses and fittings
_______ Power trim and tilt fluid level checked
_______ Power trim and tilt operational
_______ Check stern drive lower unit oil levels
_______ Visual inspection of the engines
_______ Transducer installation is sealed and secured
_______ 12 Volt receptacles tested
_______ Command Link Gauges have main bus leads and end of line resistors in place
_______ Raw water outlet functional
_______ Check raw water wash down system
_______ All 12 Volt receptacles tested
_______ All battery cables secure - POSITIVE & GROUND
NOTES:____________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
4-5
Storage And Commissioning
4-5