Chris-Craft 32 Launch (RJ) Owner's Manual page 153

MARINE UPHOLSTERY (Continued)
Re-treating the fabric for ease of cleaning
As part of the finishing process, Sunbrella fabrics are treated with a fluorocarbon finish, which enhances
water repellency. This finish is designed to last for several years, but must be replenished after a thorough
cleaning. Based on test results, Glen Raven recommends 303 High Tech Fabric Guard™ as the preferred
re-treatment product for Sunbrella fabrics. Fabrics should be re-treated after thorough cleaning or after five
years of use.
For more information, visit
Applying 303 High Tech Fabric Guard
303 should be applied to Sunbrella fabrics after each thorough cleaning, which typically removes the origi-
nal finish and reduces the fabric's water repellency.
Clean Sunbrella fabric, using one of the cleaning methods.
Allow Sunbrella to completely air dry.
Apply 303 Fabric Guard in a well-ventilated area following instructions on the container.
Apply 303 in a thin, even coat and allow fabric to dry completely.
Apply a second thin, even coating of 303. (Two light coatings are more effective in restoring fabric water
resistance than a single heavy coating.
A 15-ounce bottle provides coverage of up to 50 square feet of fabric.)
Professional cleaners
In evaluating the services of a professional firm, you should inquire about the firm's experience in working
with Sunbrella fabrics and knowledge of cleaning and re-treatment requirements.
DO NOT dry clean Sunbrella fabrics.
Helpful hints
Protect the area around your Sunbrella fabric when using a bleach solution – bleach may discolor non-
Sunbrella fabrics. Always rinse Sunbrella thoroughly to completely remove bleach.
Please be aware of the environment when cleaning with bleach. Bleach can have harmful effects on the
natural environment around you. We do not advise using bleach if you are surrounded by a body of water
or other environment that could be affected.
Sunbrella air-dries very quickly. Machine drying is not necessary.
If fabric has some wrinkling, use an iron, if necessary, but only on the synthetic setting. As some irons
exceed the recommended temperature on the synthetic setting, test a small inconspicuous area before
ironing entire piece.
DO NOT use a steamer or iron set to steam setting.
4-21
Storage And Commissioning
www.303products.com.
™
4-21