User Codes; Extended Functionality; Led Operation; Safe Mode - Honeywell Tuxedo Touch User Manual

User Codes

Each user must be assigned a name with a corresponding 4-digit user code in order to gain access to authorized features and
functions. Users for the system are programmed in a central user setup location that provides the specific questions for
authorization level, partition assignment, and RF zone assignment.

Extended Functionality

Extended functions are advanced functions that can be accessed through a standard alpha keypad or through the
console emulation mode on your Tuxedo Touch touch-screen. Refer to your Control Panel User Guide for these
features.
Note: For SIA installations used with a VISTA-128BPTSIA Control, see the SIA CP-01 Quick Reference Chart located on
MyWebTech, Document # 800-09699.

LED Operation

The Tuxedo Touch Keypad has three LEDs as follows:
NOTE: If the Screen Blackout (*EN50131 Display) feature is enabled (see below) the keypad returns to the "Home" screen and
the "Armed" and "Ready" status LEDs turn OFF after 30 seconds. The keypad will remain in this state until a valid user code is
entered.
*The EN50131 Display compliance feature is a European Standard designed to prevent unauthorized users from viewing the
status of the Security System.

Safe Mode

The Keypad contains a Safe Mode of operation. In the rare event that the keypad cannot successfully communicate in its graphic
mode with the control panel, the Safe Mode is a backup mode that ensures that you can communicate with your system. Refer to
the Safe Mode section for further information.
About the System (cont'd)
SD/SDHC CARD Slot
ARMED (RED) LED
ON – System is armed.
OFF – System is not armed.
READY (GREEN) LED
ON – System is disarmed and ready to arm.
OFF – System is armed or disarmed but not
ready. If disarmed, faults or troubles are present.
MESSAGE (YELLOW) LED
FLASHING – The system contains new
message(s) for the User.
OFF – No new messages.
RESET BUTTON
Press to reset keypad
10
6280-001-V0