3. Remove the heat sink from the VGA module by removing the three M2.5x3 screws. Follow
the order indicated by the numbers on the heat sink to remove the screws.
Installing the VGA Module
To install the VGA module, follow the steps below and refer to the figure in the preceding
section:
CAUTION: If you remove the heat sink, use the grease tool to remove the grease on the
VGA board and heat sink. Reapply fresh grease before installing the heat sink.
1. Connect the heat sink to the VGA module by securing it with three M2.5x3 screws. Follow
the order indicated by the numbers on the heat sink to tighten the screws.
2. Seat the VGA module and secure the module by placing the M2.5x6 and M2.5x16 screws
and tightening them.
Satellite M100 Series Maintenance Manual
Figure 4-69
Removing the VGA module heat sink
[CONFIDENTIAL]
4 Replacement Procedures
4-61