Toshiba Satellite M100 Maintenance Manual page 170

4 Replacement Procedures
Installing the Display Assembly
To install the display assembly, follow the steps below and refer to the figures in the preceding
section.
1. Seat the display assembly, taking care not to crush to the LCD display cable, the LCD
power cable, the wireless LAN antenna connectors, or the Bluetooth connector.
2. Secure two M2.5x6 black screws to each hinge to connect the assembly to the top cover.
3. Secure two black M2.5x6 black screws to the computer's rear side. They hold the display
assembly in place.
4. Feed the wireless LAN module's antennae wires through the indented track on the system
board towards the rear side.
5. Connect the Bluetooth connector to the Bluetooth module.
6. Connect the LCD power cable to the top chassis.
7. Reinstall the keyboard and wireless LAN module.
4-44
[CONFIDENTIAL]
Satellite M100 Series Maintenance Manual