Sony DMX-R100 Operating Instructions Manual page 52

Menu Windows
1 Display window
Displays the levels of the AUX SEND 1 to 8 busses.
The level of the AUX send bus is adjusted using AUX
SEND controls 1 to 8 on the AUX SEND section on
the Parameter Setting panel.
When the AUX send bus is set to stereo mode, the
display windows of the even channels indicate the
panning/balance settings.
To set the AUX SEND bus to stereo mode, select the
MASTER button on the PAGES section and then
access one of the AUX SEND faders. On the display,
select STEREO using the channel mode select button
on the CHANNEL window.
2 ON buttons 1 to 8
Touch the desired button and it turns green indicating it
is on. The accessed channel is sent to the
corresponding AUX send bus.
For busses set in stereo mode, the channels are
switched ON/OFF by linking them as shown below.
Linking of AUX send buses
52
Chapter 3 Menu
3 PRE (prefader) buttons 1 to 8
Touch the desired button and turns green to indicate
PRE. The pre-fader signal of the channel is routed.
When the button is routed, the post-fader signal is sent
out.
For buses set in stereo mode, the odd and even
channels are linked, the PRE button of the even
channel toggles the pan on and off.