Sony DMX-R100 Operating Instructions Manual page 22

Locations and Functions of Parts and Controls
7 High-cut filter section
FREQ control: Sets the cut-off frequency of the high-
cut filter.
IN button: Press this button to activate the high-cut
filter.
Note
The high-cut filter and low-cut filter operate regardless
of the setting of the Equalizer IN button.
AUX SEND section and CHANNEL button
1 AUX SEND control
2 ON button
3 PRE button
4 CHANNEL buttons
1 AUX SEND control 2 ON button 3 PRE
button
Press the ON button so that it lights. The channel
signal is sent to the corresponding AUX bus. AUX
SEND controls 1 to 8 allow you to adjust the level of
the corresponding AUX send bus.
If the AUX SEND bus is set to stereo, the even number
controls function as the pan control and the odd/even
number ON buttons are linked.
When the PRE button is lit, the pre-fader signal is sent
to the corresponding AUX bus. When the PRE button
is not lit, the post-fader signal is sent.
The AUX SEND control, ON and PRE buttons are
available for both snapshot and dynamic automation.
4 CHANNEL buttons
Allow the access channel number to be incremented or
decremented - allowing fast use of the Assignment
panel.
22
Chapter 2 Locations and Functions of Parts and Controls
To open the EQALIZER/FILTER window
directly from the panel
If the AUTO ZOOM button is lit (ON) in the
MISC SETUP window, the window directly
switches to the EQUALIZER/FILTER window,
when you activate the equalizer by pressing the
corresponding IN button in each section.
For further information about the MISC SETUP
window, see page 94.
1 2 3
ON PRE ON PRE ON PRE
AUX SEND
4 5 6
ON PRE ON PRE ON PRE
CHANNEL
7 8
ON PRE ON PRE