Sony DMX-R100 Operating Instructions Manual page 24

Locations and Functions of Parts and Controls
4 SOLO MODE section
Changes the function of the channel SOLO buttons.
SOLO button: When this button is lit, the SOLO
buttons on the channel strip panel function as
'destructive solo' buttons and cause all other channels
to cut.
For detailed information on how to set SOLO disabled, see
"SOLO buttons" on the MONITOR window on page 69.
Note
The solo mode affects both monitoring and the mix
output. The solo mode is operational for stereo pan
and surround sound MTR bus monitoring.
AFL (after-fader listening) button: When this button
is lit, the SOLO buttons on the channel strip panel
function as the AFL buttons. The AFL signal is sent to
the monitor, regardless of the settings in the FADERS
section.
PFL (pre-fader listening) button: When this button
is lit, the SOLO buttons on the channel strip panel
function as the PFL buttons. The PFL signal is sent to
the monitor, regardless of the settings in the FADERS
section.
CANCEL button: Provides an automatic method of
cancelling all SOLO'd channels (set in SOLO mode).
FADER
CUT
PAN
CUT
PAN
SOLO
LOGIC
5 HEADPHONES control
Adjusts the volume of the headphones.
24
Chapter 2 Locations and Functions of Parts and Controls
PGM
AFL
SOLO SW
PFL
AFL/PFL
SOLO MODE
MTR
SOLO
Control room monitor section and PGM
bus section
SOURCES
EXT 2T-1 2T-2
PGM AUX MTR
CR MONITOR
SETUP DIM CUT
ACCESS
10 10
5 5
0 0
5 5
10 10
20 20
30 30
40 40
60 60
PROGRAM
1 SOURCE section
Selects the signal for the control room monitor (which
is output to the CR MONITOR connector on the rear
panel).
EXT button: When this button is lit, the EXT
MONITOR signal selected on the MONITOR window
(page 67) is monitored.
2T-1 button: When this button is lit, the signal input
to the 2TR IN 1 connector is monitored.
Control room monitor section
1 SOURCE section
2 CR MONITOR section
PGM bus section
3 ACCESS button
4 PROGRAM fader