Installing The Fork Legs; Removing The Fork Protector - Husqvarna FE 350 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.8

Installing the fork legs

12.9

Removing the fork protector

–
Release screws
–
Release screws
C00579-10
x
Main work
–
Position the fork legs.
Info
The compression damping is located in the left fork leg COMP (white adjust-
ing screw). The rebound damping is located in the right fork leg REB (red
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the upper
triple clamp.
C00580-10
Position bleeder screws
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
C00579-11
–
Position the brake caliper and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable binder
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
C00578-10
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
x
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs. (
. Take out the left fork leg.
4
. Take out the right fork leg.
5
toward the front.
1
.
2
.
3
M8
.
5
( p. 74)
x
p. 84)
p. 41)
( p. 74)
x
p. 42)
M8 17 Nm (12.5 lbf ft)
M8 15 Nm (11.1 lbf ft)
.
4
25 Nm Loctite
(18.4 lbf ft)
p. 82)
p. 82)
43
® 243™
.
6