Checking The Headlight Setting; Adjusting The Headlight Range - Husqvarna FE 350 EU Owner's Manual

Husqvarna fe 350 motorcycles 2014 owner's manual
Table of Contents

Advertisement

15
ELECTRICAL SYSTEM
15.10

Checking the headlight setting

15.11

Adjusting the headlight range

Main work
Remove the screw on the rear of the turn signal housing.
Carefully remove diffuser
Lightly squeeze orange cap
Press the turn signal bulb lightly into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
Press the new turn signal bulb carefully into the socket and turn it clockwise until it
stops.
Turn signal (R10W / socket BA15s) (
Mount the orange cap.
Position the diffuser.
Insert the screw and turn it counterclockwise first until it engages in the thread with a
light jerk. Tighten the screw slightly.
101722-10
Finishing work
Check that the turn signal system is functioning properly.
Position the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
Make another mark a distance
Guideline
Distance
Position the vehicle vertically a distance
Guideline
Distance
400726-10
The rider now sits down on the motorcycle.
Switch on the low beam.
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
»
If the light-dark border does not meet specifications:
Adjust the headlight range. (
Preparatory work
Check the headlight setting. (
Main work
Adjust the headlight range of the headlight by turning adjusting screw
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver (instructions on how to apply the mark: Checking the head-
light setting).
Info
Turn clockwise to reduce the headlight range; turn counterclockwise to
B01783-10
increase the headlight range.
A change in weight on the vehicle may require a correction of the headlight
range.
.
1
in the area of the holding lugs and take it off.
2
under the first mark.
B
B
A
p. 84)
p. 105)
5 cm (2 in)
away from the wall.
A
5 m (16 ft)
p. 84)
84
.
1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fe 350 ausFe 350 usaFe 2502014 fe 350

Table of Contents