Adding Engine Oil - Husqvarna FE 350 EU Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.4

Adding engine oil

Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the engine oil level. (
–
Install the engine guard. (
Main work
–
Remove the oil filler plug
–
Fill engine oil to the middle
Engine oil (SAE 10W/50) (
Alternative 1
Engine oil (SAE 10W/60) (
Info
For optimal performance of the engine oil, do not mix different types of engine
oil.
If appropriate, change the engine oil.
–
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and/or death.
–
B01768-10
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the engine oil level. (
p. 91)
p. 64)
with the O-ring from the clutch cover.
1
of the level viewer.
B
p. 108)
p. 108)
When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effec-
tive exhaust extraction system.
p. 91)
94