15
ELECTRICAL SYSTEM
15.8
Changing the headlight bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
15.9
Changing the turn signal bulb (FE 350 EU, FE 350 AUS)
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
–
Position rubber bands
The wiring harness and brake line
B01784-10
Finishing work
–
Check the headlight setting. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Turn protection cap
and lift it off.
–
Pull bulb socket
L00269-10
–
Press headlight bulb
wise, and pull it out.
–
Insert the new headlight bulb.
Headlight (S2 / socket BA20d) (
–
Insert the protection cap with the bulb socket into the reflector and turn it all the way
clockwise.
–
Insert the bulb socket of the parking light into the reflector.
L00270-10
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
around the fork legs and close them.
4
are routed in front of the headlight mask.
5
p. 84)
with the bulb socket beneath it all the way counterclockwise
1
of the parking light out of the reflector.
2
lightly into the bulb socket, turn it all the way counterclock-
3
p. 105)
p. 84)
p. 82)
p. 82)
83