Additionally Securing The Rubber Grip; Adjusting The Basic Position Of The Clutch Lever; Checking/Rectifying The Fluid Level Of The Hydraulic Clutch; Changing The Hydraulic Clutch Fluid - Husqvarna FE 350 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.46

Additionally securing the rubber grip

12.47

Adjusting the basic position of the clutch lever

12.48

Checking/rectifying the fluid level of the hydraulic clutch

Info
The fluid level rises with increased wear of the clutch lining discs.
12.49

Changing the hydraulic clutch fluid

Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Preparatory work
–
Check the rubber grip. (
Main work
–
Secure the rubber grip at two points using the securing wire.
Securing wire (54812016000)
Wire twister forceps (U6907854)
The twisted wire ends face away from the hands and are bent toward the rubber
grip.
401198-01
–
Adjust the basic setting of the clutch lever to your hand size by turning adjusting
screw .
1
Info
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between
the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
C00530-11
Do not make any adjustments while riding!
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level below container rim
» If the fluid level does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
B01538-10
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
x
p. 62)
.
1
with membrane .
2 3
p. 108)
4 mm (0.16 in)
63