12
SERVICE WORK ON THE CHASSIS
12.18
Removing the shock absorber
12.19
Installing the shock absorber
12.20
Removing the seat
12.21
Mounting the seat
x
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the right side cover. (
–
Remove the main silencer. (
–
Remove the seat. (
–
Remove the manifold.
Main work
–
Carefully take the shock absorber out of the vehicle toward the top.
B01820-01
x
Main work
–
Carefully position the shock absorber into the vehicle from above.
B01820-01
Finishing work
–
Install the manifold.
–
Mount the seat. (
–
Install the main silencer. (
–
Install the right side cover. (
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Lift up the seat at the rear, pull it back, and then lift it off.
B01819-10
–
Attach the front of the seat to the collar bushing of the fuel tank and lower the seat at
the rear while pushing forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screws for securing the seat.
Guideline
Remaining screws, chassis
B01818-01
p. 41)
p. 55)
p. 54)
p. 49)
(
p. 52)
x
(
p. 53)
x
p. 49)
p. 54)
p. 56)
in the recessed grips on the left and right.
1
M6
p. 41)
10 Nm (7.4 lbf ft)
49