12
SERVICE WORK ON THE CHASSIS
12.10
Installing the fork protector
12.11
Removing the lower triple clamp
Main work
–
Remove screws
–
Remove the screws on the right fork leg. Remove the fork protector upwards.
C00565-10
x
Main work
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
C00565-10
Finishing work
–
Install the fork legs.
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
x
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs. (
–
Remove the front fender. (
Main work
–
Open cable holder
C00599-10
–
Remove screw
dlebar and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
C00566-13
on the left fork leg. Remove the fork protector upwards.
1
(
p. 43)
x
x
(
p. 74)
p. 84)
p. 41)
(
p. 74)
x
p. 42)
p. 48)
in front of the right radiator and detach the wiring harness.
1
. Remove screw
, take off the upper triple clamp with the han-
2
3
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 82)
p. 82)
44
.
1