The Media Heating System Doesn't Warm Up; Cannot Cut Off The Media - Roland VersaArt RA-640 User Manual

Is a message displayed on the screen?
 P. 122 "A Message Appears," p. 124, "An Error Message Appears"
Is the cable connected?
Connect the cable securely.
 "Setup Guide"
Is the network routing appropriate?
Try connecting the computer and the machine to the same hub, or connecting them directly using a crossover
cable. If this makes it possible to perform output, it means the problem is in the network itself.
Are the network settings correct?
If the cable connections are secure and no problem is found in the network itself, make sure that the IP ad-
dress and other such settings are appropriate. The settings on both the machine and the computer must be
appropriate. Redo the settings, checking to ensure that the IP address doesn't conflict with the IP address for
another device on the network, that the settings have no typing errors, and for other such problems.
 "Setup Guide" , p. 109 "Viewing Information about the System of This Machine"

The Media Heating System Doesn't Warm Up

Is media loaded?
The media heating system does not warm up to the preset temperature when
Load media and wait for the machine to warm up.
 P. 87, "Fully Utilize the Media Heating System"
Is the temperature of the room too low?
Use the machine in an environment where the temperature is 20 to 32°C (68 to 90°F).

Cannot cut off the media

Is the separating knife mounted?
If the separating knife is not mounted, you cannot cut off the media.
 P. 80, "Replacing the Separating Knife"
Are the cut rail mounted?
If the cut rail is not mounted, you cannot cut off the media.
 P. 80, "Replacing the Separating Knife"
Printer Does Not Start Up!
is dark (by default).
113
6