A Message Appears - Roland VersaArt RA-640 User Manual

A Message Appears

These are the main messages that appear on the machine's display to prompt correct operation.
They do not indicate any error. Follow the prompts and take action accordingly.
[ 1 ■ 2 ■ 3 ■ 4 ■ 5 ■ 6 ■ 7 ■ 8 ■ ]
Only a small amount of ink remains. Replace the cartridge indicated by the flashing number with a new
cartridge.
[PRESS THE POWER KEY TO CLEAN]
This appears when the machine has been unused for about one month. Switch on the sub power once a
month.
 P. 82, "When Not in Use for a Prolonged Period"
[CLOSE THE COVER (FRONT COVER, COVER L or COVER R]
Close the front cover, cover L, or cover R. For safety, the carriage does not operate while a cover is open.
[SHEET NOT LOADED SETUP SHEET]
Load media. This message appears when an attempt to perform a printing test was made while no media
was loaded.
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged fluid collects in the drain bottle. To clear the message,
press
the bottle.
 P. 60, "Disposing of Discharged Ink"
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain bottle, then press
 P. 60, "Disposing of Discharged Ink"
[NOW HEATING...]
Wait until the media heating system reaches the preset temperature. Printing starts when
You can stop printing by holding down
makes printing start immediately, without waiting to reach the preset temperature.
6
[TIME FOR MAINTENANCE]
It is time to clean the printer heads manually. After verifying, press
 P. 66, "Manual Cleaning of Print Head"
[TIME FOR WIPER (FELT) REPLACE]
It is time to replace the wiper or felt wiper. After verifying, press
 P. 74, "Replacing the Wiper," p.77 "Replacing the Felt Wiper"
122
. If this screen appears, go to the [DRAIN BOTTLE] menu and discard the discharged fluid in
for one second or longer while this is displayed. Pressing
.
.
.
lights up.