Viewing Phone Information; Using Ivr On The Spa501G Ip Phone - Cisco 501G Administration Manual

Getting Started

Viewing Phone Information

Viewing Phone Information

Using IVR on the SPA501G IP Phone

Cisco SPA500 Series and WIP310 IP Phone Administration Guide
After you log on to the web UI (see
Interface" section on page
SPA500 Series or Wireless-G IP Phone by clicking the Info tab. The Info tab shows
information about all phone extensions, including phone statistics and the
registration status. All fields are read-only.
See "Info Tab" section on page 179
The SPA501G provides an IVR menu to perform configuration tasks and obtain
information about the phone.
To access the IVR menu, press the Settings button. Enter the number of the option
and press #. Some menus require entering of further information or numbers.
You have the following options:
Number Option
100 Tells you if Dynamic Host Configuration Protocol (DHCP) is enabled.
110 Recites the IP address of the phone.
120 Recites the netmask of the phone.
130 Recites the gateway address.
140 Recites the MAC (hardware) address of the phone.
150 Recites the phone software version.
160 Recites the primary DNS server address.
170 Recites the HTTP port on which the web server listens. Defaults to 80.
180 Recites the IP multicast address (used by the SPA9000 to communicate
with the IP phone).
220 Recites the method of call control (SIP or SPCP).
"Using the Web Administration User
11), you can check the current status of the Cisco
for more information about the fields.
1
17