Configuring Sip; Configuring Sip Parameters - Cisco 501G Administration Manual

Configuring SIP, SPCP, and NAT

Configuring SIP

Configuring SIP
STEP 1
STEP 2
STEP 3
STEP 4
Cisco SPA500 Series and WIP310 IP Phone Administration Guide
SIP settings for the Cisco SPA500 Series and Wireless IP Phones are configured
for the phone in general and for individual extensions. The following sections
describe SIP configuration.

Configuring SIP Parameters

To configure general SIP parameters, including enabling CTI:
Log in to the web administration interface.
Click Admin Login and advanced.
Click the SIP tab.
Under SIP Parameters, make the necessary configuration changes to the fields
shown in the following table and click Submit All Changes.
Parameter
SIP Reg User
Agent Name
SIP Accept
Language
DTMF Relay MIME
Type
Remove Last Reg
Description
User-Agent name used in a REGISTER request. If not specified,
the SIP User Agent Name is also used for the REGISTER request.
Defaults to blank.
Accept-Language header used. If empty, the header is not
included.
Defaults to blank.
MIME Type used in a SIP INFO message to signal a DTMF event.
This parameter must match that of the service provider.
Defaults to application/dtmf-relay.
If set to yes, removes the last registration before re-registering (if
the value is different). Defaults to no.
4
71