Mounting the Battery and Setting the Battery Type
Using an Anton/Bauer Battery Pack
1
Mount the Anton/Bauer battery pack.
Power supply output
connector for lighting
<For your information>
The Anton/Bauer battery holder includes both a power
supply output connector for lighting and a lighting control
switch, which are convenient when attaching a light.
Please contact Anton/Bauer for information about the
lighting system.
2
Insert the battery and slide it in the direction of the
arrow.
Release lever
<For your information>
Removing the battery pack
Completely push down and hold the release lever on
the battery holder. Then, slide the battery pack in the
opposite direction to the arrow while holding the lever
down.
Anton/Bauer
Battery Pack
Lighting
control switch
3
Setting the battery type.
Select the battery type listed under BATTERY
SELECT. Select BATTERY SELECT from the
<BATTERY/P2CARD> screen in the MAIN
OPERATION page.
Please refer to [BATTERY SETTING1] (page 164) for
more information.
The following Anton/Bauer batteries can be used:
•
PROTECT14
•
TRIMPAC14
•
HYTRON50
•
HYTRON100
•
HYTRON120
•
DIONIC90
•
DIONIC100
•
DIONIC160
Note
To use DIONIC, please set it as DIONIC90.
Preparation Power Supply
89