Selection Of Video Output Signals - Panasonic AJ-HPX2100E Operating Instructions Manual

Selection of video output signals

The unit employs the VIDEO OUT connector and the MON OUT connector as connectors for outputting video signals.
Settings of signals output from VIDEO OUT connector
The signal modes for outputting signals from the VIDEO
OUT connector are switched with the VIDEO OUT switch.
HD SDI:
To output the HD SDI signals. When the camera-
recorder is set to the SD mode, SD-SDI signals are
output.
SD SDI:
To output the SD SDI signals. (Signals are down-
converted in HD mode.)
VBS:
To output the composite video signals. (Signals are
down-converted in HD mode.)
The signals output from the MON OUT connector or
VIDEO OUT connector are switched with the OUTPUT
SEL switch.
However, the switching operation is not acknowledged
during the recording operation.
MEM
During EE, such as recording, video images taken
by the camera are output. Meanwhile, signals on
the P2 card are output during playback.
CAM
The camera images are output at all times.
OFF
No signal is output from the VIDEO OUT or MON
OUT connector.
Set the characters to be superimposed on the signals
output from the VIDEO OUT connector by using the
VIDEO OUT CHARACTER switch and the OUTPUT ITEM
item on the menu (<OUTPUT SEL> screen on the
SYSTEM SETTING page).
72
Adjustments and Settings for Recording : Selection of video output signals
VIDEO OUT switch
OUTPUT SEL switch
VIDEO OUT CHARACTER
switch
Variable
Item
range
OUTPUT ITEM MENU Set the characters to be
superimposed on the output signals
ONLY
from the VIDEO OUT connector.
TC
MENU ONLY:
STATUS
TC:
STATUS:
Remarks
The menu screen is superimposed
only when the menu is accessed.
This normally displays nothing.
Time codes are superimposed
(when the menu is accessed, the
menu screen is superimposed.)
The characters that are the same
as the characters superimposed in
the viewfinder screen are
superimposed.
(When the menu is accessed, the
menu screen is superimposed.)