Setting The Shutter Mode And Speed - Panasonic AJ-HPX2100E Operating Instructions Manual

Setting the Shutter Mode and Speed

The shutter speed in any shutter mode is set using the
SHUTTER switch.
In SYNCHRO SCAN mode, shutter speed can be switched
easily, using the synchro-scan adjustment switches (+/–)
on the side panel.
Note that the range of selectable shutter speeds may be
pre-defined; whether or not to use the SYNCHRO SCAN
mode may be determined through the <SHUTTER
SPEED> and <SHUTTER SELECT> screens. These
screens are accessible through the menu on the CAM
OPERATION page.
The selected shutter speed is retained even if the unit is
turned off.
# < SHUTTER SPEED >
SYNCHRO SCAN :ON
POSITION1 :ON
POSITION2 :ON
POSITION3 :ON
POSITION4 :ON
POSITION5 :ON
POSITION6 :ON
# < SHUTTER SELECT >
POSITION1 SEL :1/100
POSITION2 SEL :1/120
POSITION3 SEL :1/250
POSITION4 SEL :1/500
POSITION5 SEL :1/1000
POSITION6 SEL :1/2000
Placing the Camera-recorder in SYNCHRO SCAN Mode
To place the camera-recorder in SYNCHRO SCAN mode,
follow the steps below.
1
Press the SHUTTER switch positioned at [ON]
towards [SEL], to place the camera-recorder in
SYNCHRO SCAN mode.
2
In the SYNCHRO SCAN mode, it is possible to
change the shutter speed continuously by operating
the SYNCHRO SCAN (+ and –) buttons.
1
Press the SHUTTER switch, positioned at [ON],
towards [SEL].
2
Once more, press the SHUTTER switch towards
[SEL]. Repeat this switchover until the desired mode
or speed appears in the viewfinder screen.
If all modes and speeds are available, the display
changes in the following order:
POSITION1
Viewfinder displays relating to the shutter
See [Viewfinder Screen Status Displays] (page 61).
SYNCHRO SCAN ADJUSTMENT buttons (+/–)
SHUTTER switch
Adjustments and Settings for Recording : Setting the Electronic Shutter
SHUTTER switch
NORMAL mode
POSITION2 POSITION3 POSITION4
SYNCHRO
SCAN mode
POSITION5 POSITION6
43