Table of Contents
Advertisement
Mounting the Battery and Setting the Battery Type
Using an Anton/Bauer Battery Pack
1
Mount the Anton/Bauer battery pack.
Insert the battery and slide it in the direction of the
arrow.
Release lever
<For your information>
Removing the battery pack
Completely push down and hold the release lever on
the battery holder. Then, slide the battery pack in the
opposite direction to the arrow while holding the lever
down.
2
Setting the battery type.
Select the battery type listed under BATTERY SELECT.
The menu item BATTERY SELECT is found in the
<BATTERY/P2CARD> screen on the MAIN
OPERATION page.
The following Anton/Bauer batteries can be used:
•
HYTRON140
•
DIONIC90
•
DIONIC160
1
Anton/Bauer
Battery Pack
2
When using a V-mount type battery pack
Mount the V-mount adapter plate.
Setting the battery type.
Select the battery type listed under BATTERY SELECT.
When using another battery which cannot be selected
using the BATTERY SELECT item setting, select TYPE
A, TYPE B or TYPE C, and set the items that
correspond to the characteristics of the battery. These
menu items are found in the <BATTERY SETTING>
screen on the MAIN OPERATION page.
Note
For information about the V-mount adapter plate, please
contact the store where you purchased the camera-
recorder.
Preparation: Power Supply
109
Advertisement
Table of Contents
