Transmitter/Receiver Learn Routine - Avital 2000 Operation Manual

transmitter/receiver learn routine

Transmitters are taught to the system using the Learn Routine. This system will learn up to four transmitters.
Both transmitters are factory programmed using
and Buttons and
can be added to the system using the Learn Routine.
1. Key. Turn the ignition to the run position. (The YELLOW H1/9 wire must be already be con-
nected.)
2. Valet
times corresponding to the desired channel number (see chart below). Then press the
Valet/Program switch once more and HOLD it. The LED will blink to indicate the selected
channel and the horn will honk (if connected). Do not release the Valet/Program switch.
Pressing the Valet/Program Switch five times will delete all transmitters that are pro-
grammed into the system and will also change the operating settings back to the default
settings (see Operating Settings Learn Routine section of this guide). To use this option, select
Channel 5 (LED will blink five times) then transmit from any button of a known remote.
CHANNEL
NUMBER
1
2
3
4
5
*NOTE: For the Auto Learn Standard Configuration, see the Transmitter Configuration
section of this guide.
3. Transmit. While HOLDING the Valet®/Program switch, press the button on the transmit-
ter that you would like to control the selected receiver channel. One honk will confirm that
the code has been learned.
NOTE: For Channel 4, press
button transmitter.
© 2001 Directed Electronics, Inc. Vista, CA
together operate Channel Three. This configuration can be changed or new remotes
® /Program switch. Press and release the Valet
PRESS AND RELEASE
THE VALET/PROGRAM SWITCH
One time
Two times
Three times
Four times
Five times
to program the Auto Learn Standard Configuration on the two-
for arm/panic on;
® /Program switch the correct number of
TO PROGRAM FUNCTION
Arm/Panic
Disarm/Channel 2
Channel 3
Auto Learn Standard Configuration*
Delete all transmitters
™
for disarm/panic off/Channel Two;
19