Avital 2000 Operation Manual page 6

H1/9 YELLOW (+) ignition input
Connect this wire to an ignition source. This input must show (+)12V with the key in run position and during
cranking. Make sure that this wire cannot be shorted to the chassis at any point. This wire will trigger the system
if the ignition is turned on before the unit is disarmed (doors unlocked with the remote). It will also honk the
vehicle's horn and flash the parking lights (if connected).
NOTE: Feature 4 (Security Features) must be turned on in order for this wire to trigger the system.
See Features Menu section of this guide.
H1/10 BROWN (-) horn honk output
This wire supplies a (-) 200 mA output that can be used to honk the vehicle horn. It outputs a single pulse to
confirm that the doors are locked if the lock button on the remote is pressed more than once. It also outputs
two pulses to confirm that the doors are unlocked if the unlock button on the remote is pressed more than two
times. This wire also outputs pulses for 30 seconds whenever the Panic Mode is activated. If the vehicle has a
(+) horn circuit, an outboard relay can be used to interface with the system, as shown in the following diagram.
6
© 2001 Directed Electronics, Inc. Vista, CA