Transmitter/Receiver Learn Routine - Avital 3300L Installation Manual

transmitter/receiver learn routine

The system comes with two transmitters that have been taught to the receiver. Use the following learn routine to
add transmitters to the system or to change button assignments if desired.
The Valet/Program switch, plugged into the blue port, is used for programming. There is a basic sequence to
remember whenever programming this unit: Door, Key, Choose, Transmit and Release.
1.
2.
3.
CHANNEL PRESS AND RELEASE
NUMBER THE VALET/PROGRAM SWITCH
1 One Time
2 Two Times
3 Three Times
4 Four Times
5 Five Times
6 Six Times
7 Seven Times
8 Eight Times
9 Nine Times
10 Ten Times
*NOTE: See Transmitter Configuration section of this guide for a description of Auto-learn trans-
mitter programming.
**NOTE: If any button from a known transmitter is programmed to Channel 10, all transmit-
ters will be erased from memory and the system will revert to the default feature settings. (See
Features Menu section of this guide.)
26
Open a door. (The GREEN wire, H1/8, or the VIOLET, H1/6 must be connected.)
Key. Turn the ignition on. (The H1/4 YELLOW switched ignition input must be connected.)
Choose. Press and release the Valet/Program switch the number of times necessary to
access the desired channel, then press the switch once more and Hold it. The siren will
chirp and the LED will blink the number of times corresponding to the channel that has
been accessed.
TO PROGRAM FUNCTION
Arm/Disarm/Panic
Channel 2
Channel 3
Channel 4
Arm Only
Disarm Only
Panic Only
Auto-learn* (4-button and LCD 2-way transmitters)
Auto-Learn* (3-button optional transmitter)
Delete all Transmitters**
2008 Directed Electronics, Vista CA - all rights reserved