CITROEN XANTIA User Manual page 121

CHECKING AND SETTING THE VALVE TIMING
Engine : P8C (continued)
- Fit the belt in the following order :
Injection pump pulley (2) (strap tensioned), engage half the width of the belt on :
the guide roller (4), the crankshaft pinion, the water pump pinion (5), the camshaft pulley (1),
the tensioner roller (6).
- Align the belt.
- Remove the three pegs.
- Loosen the nut (9).
- Rotate the crankshaft by 2 turns until the pegs can be engaged (without refitting the pegs).
- ESSENTIAL : Never turn the crankshaft backwards.
- Tighten the nut (9) Tighten to 1 m.daN.
- Rotate the crankshaft by 2 turns to reach the pegging point (without refitting the pegs).
- ESSENTIAL : Never turn the crankshaft backwards.
- Loosen the nut (9) by one turn and allow the spring to operate.
- Tighten the nut (9) and the screw (3). Tighten to 1 m.daN.
- Refit the three pegs.
NOTE : If it is impossible to refit one of the pegs, restart the belt fitting operation.
- Remove the pegs.
SETTING THE VALVE TIMING
114
B1EP081C B1EP082C