Installing Or Replacing A Fan Interface Board - IBM J15 Manual

Procedure
1. Hold the fan module with the release tab on top and the connector pin on the bottom, as shown in
Figure 63 on page 64.
Figure 63. Fan module orientation
2. Carefully insert the fan module into the chassis until it clicks in place, as shown in Figure 64 on page
64.
Figure 64. Replace fan module
Replacing all fan modules
3. Repeat steps "1" on page 64 and "2" on page 64 for each fan module to be replaced.
4. Power on the expansion enclosure.

Installing or replacing a fan interface board

You can replace a fan interface board (FIB) in a 5U expansion enclosure.
Before you begin
This task assumes that the following conditions are met:
• You removed the fan interface board, following the process described in "Removing a fan interface
board " on page 101.
64 IBM Cloud Object Storage System
™
Version 3.15.6: J15 Appliance Manual